Chest right that you might want to check out at Flecktarn..."The Bulle MOLLE Light Chest Rig is the ultimate in super lightweight rigs, designed to carry an organised ammo and utility load within a small, unobtrusively sized rig. The chest rig comes as two parts which are pre-assembled, consisting of the yoke or shoulder harness and the load carrying panel. If required, the yoke can be removed and the extra length straps refitted in the manner of a traditional chest rig with straps crossing over in the rear.
The yoke is the standard Bulle MOLLE MLE yoke with extra wide shoulders to accommodate wearing even over armour, MOLLE loops on the upper chest and back, additional D-rings front and rear, carry handle, padded shoulder section lined on the inside with coolmax and nylon mesh material. The yoke is attached to the panel at six points via adjustable quick release buckles, these being left and right upper chest, left and right upper back and left and right sides. All of these can be detached quickly and easily by the wearer in an emergency, allowing the rig to be removed without help. The panel measures 400m wide and 190mm tall. The inbuilt carrying capacity of the panel consists of: two 185mm tall, 75mm wide, 70mm deep zip utility pockets; one 6x M4/M16/SA80 or 3x AK open magazine pouch measuring 220mm wide, 135mm tall and one flat zip compartment for documents and maps. The front of the utility pockets and the magazine pouch is fitted with MOLLE webbing to enable additional pouches to be added in the same manner as would be added to a traditional MOLLE light chest panel.
The inside of each utility zip pocket also has one 25mm Cordura retaining strap to help separate flat utilities from other contents. The size of the utility pockets allows for carriage of additional magazines, such as 2x M4, M16 or SA80 magazines or 1x AK magazines in each pocket, folded up ration items, spare screening grenades or larger FFD packets. The light chest rig boasts excellent ammo capacity in a tactically wearable package smaller than most grab bags or bandoliers making it outstanding value. Entire rig is made from 1000D Cordura nylon, with Coolmax and nylon mesh lining for the yoke. All zippers are from the YKK military strength range. Buckles, d-rings, strap adjusters and zip pulls ends are military specification Duraflex UTX Stealth parts which offer better performance, durability and heat resistance. Please note price is for ONE rig only. Accessories shown are for illustration purposes only."